Here you can get Installing a cigarette lighter socket, Fitting a cigarette lighter socket and Socket illumination.
Although you’ll not smoke, fitting a cigarette lighter inside your car might be more useful than you think that. Car accessory shops are now selling a spread of helpful, practical electrical accessories that are designed especially to figure from a cigarette lighter socket.
Examples include map reading lights, inspection lamps, car vacuum cleaners and private cooling fans . of these simply plug into the lighter socket and you’ll wish to fit such a lighter simply to power these accessories. Fitting a cigar lighter has the further advantage of lowering on the amount of holes you would like to drill into the dashboard or centre console to suit accessories, since variety of various accessories can be run off the same lighter socket.
Ways of fitting
On many cars, if a lighter isn’t included as a standard fitment, you’ll well find that there’s already a hole within the dashboard designed to accept one. You will probably find that the opening has been blanked off with a plug. to suit the lighter, all you would like to try to to is to prise out the plug and fit the lighter in its place – the required wiring for the lighter will usually be already built-in around the back of the opening.
Older cars, however, might not have a special hole able to accept a cigarette lighter. in this case you’ll need to cut your own hole, either within the dashboard or within the centre console, fit the lighter socket and wire it up.
Choices
You will find that there’s a wide range of aftermarket cigarette lighters in car accessory shops. some extent to watch out for when buying one is that some have a built-in light, often alittle ring round the base of the lighter. you’ll find this handy within the dark, particularly if you’re fitting the lighter within the rear passenger compartment. Otherwise, there’s little to settle on between different aftermarket lighters.
Fitting a cigarette lighter socket
Positioning
If there’s no ready-made hole, find a suitable position on the dash or the centre console. confirm the lighter unit won’t obstruct anything when fitted. it’s best to seek out an edge within the centre of the dash to offer both driver and passenger quick access.
Mark out
Cover your chosen area with masking tape to guard the surface. Use a pair of compasses to draw a circle on the masking paper slightly smaller than the diameter of the lighter socket body. this is often to make sure you get an honest tight fit the lighter.
Cut out hole
Start by drilling a pilot hole within the centre of the marked circle. Use a rather bigger drill to open the opening out further. Continue this process until the opening is that the same size because the circle. If you haven’t got a drill large enough to drill the opening out completely use a file to open out the opening.
Fit the socket
Remove the masking tape from the dash or centre console. Remove the lighter element and casing from the socket body. Insert the socket into the opening from the front of the dash. confirm the trim ring (if fitted) is in position under the top of the socket. Open the opening out a touch more with the file if necessary.
Securing the socket
Working behind the dash or underneath the console, offer the casing or threaded ring to the socket body. The casing screws on to the rear of the socket. Tighten the casing on to the socket, making sure it’s tight and there’s no chance of it becoming loose which could cause a short circuit.
Wiring up
Disconnect the battery for safety. Run a wire from a permanentlive feed to the centre terminal on the socket. Fit an in-line fuse to the present wire (35 amp). Join a wire to the world terminal on the casing and run it to a convenient point on the body. Reconnect the battery and test the lighter.
Socket illumination
Some lighters are fitted with their own illumination bulb. To wire this up connect the illumination feed wire to the sidelight circuit . Use a Scotchlok connector to splice the wire in. Alternatively the wire are often connected on to the sidelight fuse terminal on its output side. *Socket as long as you wish, you’ll be ready to buy just the socket and casing without the lighter itself. These are usually sold as service replacements if your original socket is faulty. The fitting procedure is exactly the same.
